Skip to content

Raspberry Pi – Setting a static IPv4 address

It run me mad, as I tried to change the IP address of my Raspberry to a static one. I changed literally everything in  /etc/network/interfaces and reloaded, restarted and reboot the device over and over.

iface eth0 inet static
address 192.168.0.207
netmask 255.255.255.0
network 192.168.0.0
broadcast 192.168.0.255
gateway 192.168.0.

As the above configuration did not help a lot, I figured out that based on the Raspberry model, you need to change settings on various places.

First run

cat /proc/cpuinfo

to determine you model. While getting something like

pi@raspberrypi:~ $ cat /proc/cpuinfo
processor    : 0
model name    : ARMv6-compatible processor rev 7 (v6l)
BogoMIPS    : 2.00
Features    : half thumb fastmult vfp edsp java tls
CPU implementer    : 0x41
CPU architecture: 7
CPU variant    : 0x0
CPU part    : 0xb76
CPU revision    : 7

Hardware    : BCM2708
Revision    : 0004
Serial        : 000000004715b608

you need to use the hardware revision and

Model and Pi Revision 256MB Hardware Revision Code from cpuinfo
Model B Revision 1.0 256MB 0002
Model B Revision 1.0 + ECN0001 (no fuses, D14 removed) 256MB 0003
Model B Revision 2.0
Mounting holes
256MB 0004
0005
0006
Model A
Mounting holes
256MB 0007
0008
0009
Model B Revision 2.0
Mounting holes
512MB 000d
000e
000f
Model B+ 512MB 0010
Compute Module 512MB 0011
Model A+ 256MB 0012
Pi 2 Model B 1GB a01041 (Sony, UK)
a21041 (Embest, China)
PiZero 512MB 900092

Based on this information you need

Model a

Static IP addresses in /etc/network/interfaces is not the “prefered” way,as it is an old way and DHCPCD5 is installed.

Model b

Static IP addresses are configured in the /etc/dhcpcd.conf and it is  required that /etc/network/interfaces is set to manually.

iface eth0 inet manual

That’s all…

Published inhacksraspberry

Be First to Comment

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.